6
Operation by the contractor
Inserting member state and vehicle registration number
68
Operating instructions DTCO 4.0 - Edition 11.2018 - A2C19916900
■ Inserting member state and
vehicle registration number
By default, the country symbol and the
vehicle registration number are entered
during the installation and calibration by
the authorised specialist workshop.
Is this was not the case, the DTCO 4.0
will ask you to do so at the first insertion
of the company card.
The entries are saved in the DTCO 4.0.
IMPORTANT
Correctly inserting registration number
You may only enter the vehicle registra-
tion number into the DTCO 4.0 once.
Therefore, insert the registration exactly
as written on the number plate of the
vehicle.
Afterwards, a change can only be per-
formed by an authorised specialist
workshop holding a workshop card.
enter Vehicle
Reg. Number? Yes
Fig. 49:
Request to enter the vehicle registra-
tion number
1. Use the buttons / to select
Yes
and confirm with button .
The request to enter the member
state is displayed:
Country: D
Fig. 50:
Selection option Country
2. Select the country symbol of the
member state using the buttons /
and confirm using the button .
Next follows the request to enter the
vehicle registration number. The first po-
sition to be entered is flashing
_
.
Country: D
VS_
Fig. 51:
Entering the vehicle registration num-
ber
3. Select the required characters using
the buttons / and confirm using
the button .
IMPORTANT
Using the button you can navigate
back step by step and amend entries.
• The next position to be entered is
flashing
_
.
4. Repeat step 3 until you have entered
the complete registration number.
A maximum of 13 characters are al-
lowed.
5. Confirm the entered registration num-
ber again using the button .
Upon confirmation, a control printout
is automatically created:
Service Only!
