Varec 2920, Installation And Operation Manual, Page: 116 / 194

2920 Float & Tape Transmitter 7 MODBUS
106 Installation and Operations Manual
To Set the Unit Address
1. Press Enter to open the Main Menu.
2. Press Minus one time to select the Basic Setup menu.
3. Press Enter to open the Basic Setup menu.
4. Press Minus one time to select the Config Params menu.
5. Press Enter to open the Config Params menu.
6. Press Minus or Plus to locate the Unit Addr parameter.
7. Press Enter to modify the Unit Addr parameter.
8. Press Minus or Plus to move to the appropriate number for this device.
Note To backspace, press Minus to access the back arrow (

). Press Enter to backspace.
9. If the Unit Addr requires a two-digit number, press Enter to move to the next digit.
10. Select the second digit using Minus or Plus.
11. Press Enter to select the Return arrow (

) and save the Unit Addr.
12. Press Cancel to exit each menu and return to the Home display.
To Set the Baud Rate
1. Follow steps 1 through 5 in the 2920 FTT unit address procedure (above).
2. In the Config Params menu, select Baud Rate.
3. Press Enter to modify the Baud Rate parameter.
4. Press Minus or Plus to move to the appropriate Baud Rate for this device.
5. Continue following steps 9 through 12 above to complete the baud rate setup.
To Set the Parity
1. Follow steps 1 through 5 in the 2920 FTT unit address procedure (above).
2. In the Config Params menu, select Parity.
3. Press Enter to modify the Parity parameter.
4. Press Minus or Plus to move to the appropriate Parity for this device.
5. Continue following steps 9 through 12 above to complete the Parity setup.
To Set the Lev Com Units
1. Follow steps 1 through 5 in the 2920 FTT unit address procedure (above).
2. In the Config Params menu, select Lev Com Units.
3. Press Enter to modify the Lev Com Units parameter.
4. Press Minus or Plus to move to the appropriate Lev Com Units for this device.
5. Continue following steps 9 through 12 above to complete the baud rate setup.