VBBIM09/33/20 v5.0.3
Chapter 15 Schlage Wireless Readers
211
All Schlage wireless devices should be powered with a 12VDC power supply. The PIM-SBB (Legacy) can be
powered directly from any data channel of the
bright blue
controller that is supplying 12VDC or separately from a
local power supply.
bright blue
and the PIM-SBB communicate via RS-485 protocol.
Wiring between bright blue and PIM Module
The PIM can receive power and data from channels 1-1 through 2-16 of
bright blue
as long as the channel it is
connected to is receiving 12VDC. The PIM receives power at J1 and data at J7. J7 has two pins for Data A and
two pins for Data B. The Data A pins (TA- and RA-) must be jumpered together. The Data B pins (TB+ and RB+)
must also be jumpered together. The example below shows using Device 1-1 on the
bright blue
board to J7 and
J1 on the PIM.
Data Communication and Power between bright blue and PIM-SBB
bright blue
PIM-SBB J7
Pin 1 - A (Data A)
TA- RA- (jumpered)
Pin 2 - B (Data B)
TB+ RB+ (jumpered)
bright blue
PIM-SBB J1
Pin 3 - + (Power)
Pin 1 - PWR (Power)
Pin 4 - - (Ground)
Pin 2 - GND (Ground)
