VAMP Ltd
Generator protection relay
Operation and configuration
VAMP 210
VM210.EN004
Vamp 24h support phone: +358 (0)20 753 3264
29
6.
PC software
6.1.
PC user interface
The PC interface is intended for use on onsite parameterization
of the relay, reading measured values to a computer or for
loading relay software from a computer.
Two RS 232 serial ports are available for the connection of a
local PC, one on the front panel and one on the rear panel of
the relay. The serial ports are connected in parallel. However, if
both ports are fitted with a connection cable, only the port on
the front panel will be active. To connect a PC to a serial port,
use a connection cable of type VX 003-3.
6.1.1.
Using the VAMPSET program
See separate user’s manual for the VAMPSET software, with
the code, VMV.EN0xx. If the VAMPSET software is not
available, please download it from our web site at
www.vamp.fi.
6.2.
Remote control connection
The protection relay communicates with higher-level systems,
e.g. remote control systems, via the serial port (REMOTE) on
the rear panel of the relay.
ModBus, SPA_Bus, IEC 60870-5-103, ProfiBus or ModBus TCP
can be used as REMOTE communication protocols (see details
in Chapter 2.5.2 in technical description).
Additional operation instructions for various bus types are to
be found in their respective manual.