53
Installation
8. Mount switch plate to junction box with 2 screws
provided note: switch position left or right to suit
homeowner wishes.
9. Locate and secure magnet plate using 2 ‘long’
screws provided
10. Place and secure cover plate to box using 4 screws
provided
11. Feed cable tie through the 2 side slots of battery
cover assembly.
12. Position battery holder to rear face and secure
together with cable tie. note clearance is required
for battery snap connection.
13. Make the snap connection, load 4 AA alkaline
batteries into holder (included with
fi
replace) then
feed back into junction box assembly.
Note: Do not put batteries in the receiver, only
in the battery holder by the wall switch.
14. Test the operation of the wall switch—see page 16.
Snap connector
Cable tie
Side slot
Rear view
Front view
QUALIFIED
INSTALLER
