Valor 1700JN, Installation & Owner'S Manual

Page: 9 / 64

9
Owner’s Information
WARNING
DO NOT ATTEMPT TO TOUCH THE DATA CARD
WHILE THE FIREPLACE IS STILL HOT!
Let the
fi replace cool fi rst before touching it.
Locating Lighting, Operation and Rating
Information Card
The Lighting, Operation and Rating information is
located on a card at the right hand side of the
fi replace
opening. The card is attached under the plinth.
To access the card, remove the barrier screen, side
doors and the plinth. Grab the rolled card and pull it out
of its clip. There is important information on both sides
of the card.
Servicing Your Fireplace
If any attention is required for your appliance, contact
your supplier quoting the model number. It will be
helpful if the appliance’s serial number can also
be quoted. This number is on the rating plate. The
replacement parts are shown at the end of this manual.
Please always quote the part number and description
when requesting spare parts.
To replace the batteries :
The battery compartment is located next to the wall
switch in the vicinity of the
fi replace. Its front plate is
attached with magnets to the wall switch box.
1. Pull on the plate next to
the wall switch to access
the batteries.
2. Disconnect the snap
connector from the
battery holder.
Do not
pull the connector by
the wire!
3. Replace the batteries
with 4 AA alkaline
batteries orienting them
as indicated inside the
holder.
4. Reconnect the snap
connector to the battery
holder.
5. Put the battery holder
back in its place beside
the wall switch and snap
it in place.
Using Remote Control
Handset Wall Holder
Your fi replace equipment includes
a wall holder to store the handset.
If it hasn’t be installed, refer to the
instructions further on in this manual
for the installation.
!
Data
card
Window
The data card is located behind the front panel below
the window at the right-hand side.
Battery holder
& wall switch
Fireplace
The battery holder is located beside the wall switch.
Disconnect
connector
OWNER’S
INFORMATION