10
Owner’s Information
Wall Switch
Remote control handset
Thermostatic
Remote Control
Wall Switch
Gas valve
Fireplace Control Devices
There are two ways to control
your
fi
replace.
1. Thermostatic Remote
Control;
2. Wall Switch.
The Thermostatic Remote
Control can be programmed
to function automatically—see pages 11–15.
The Wall Switch can be used to turn on, off and to
increase or decrease the
fl
ame height—see page 16.
How to Turn Your Fireplace OFF
(including pilot)
Familiarize yourself with each of these methods before
operating your
fi
replace.
Press and hold the OFF button for a second (either on
the handset or the wall switch).
If the
fl
ames are on, they go down and you hear the
valve motor wind down. You hear a clunk and a beep
indicating that the valve has received the signal from
the remote control.
As well, familiarize yourself with the gas shut-off valve
location in your house. As indicated below, the gas is
running when the handle is parallel with the pipe. The
gas is off when the handle is perpendicular with the
pipe.
How to Ensure Your Fireplace Cannot
Be Turned ON Inadvertently
You can use one of the two following methods to
ensure that your
fi
replace will not turn on when you
don’t want it on.
First, ensure your
fi
replace is turned off—including
the pilot—and cold BEFORE going ahead.
• Turn the dial on the gas valve from the ON position
to the MAN position as shown. Turning the dial to
MAN (arrow up) will ensure that the main burner can
not come on. The pilot will remain on if it is lit.
•
Alternately, remove all batteries from the battery
holder next to the wall switch as well as the battery
from the handset.
Automatic Shut-Off
(in certain conditions)
Your
fi
replace’s remote control is equipped with an
automatic shut-off mechanism which is activated in
certain conditions. See page 15 in the
Remote Control
Operation
section for a description of this feature.
Battery holder
& wall switch
Fireplace
Receiver
Gas valve
The receiver and gas valve are located on the bottom of the
fi
replace behind the front panel. The battery holder is located
next to the wall switch.
ON: parallel to pipe
OFF:
perpendicular
to pipe
OWNER’S
INFORMATION