54
Remove front middle
platform support
Accessing air shutter
Close
Open
Injector elbow bracket,
burner side
Injector elbow
Foam
gasket
Air shutter
Setting air shutter: Loosen screw to adjust and
re-tighten afterwards.
Battery
wall holder
connection
Reset
button
Velcro
Initialize Remote Control
The receiver and the handset of the remote control sys-
tem must be initially synchronized before the
fi
rst use.
1. Insert one 9 V
alkaline
battery in the handset.
2. Locate the Reset button on the top side of the
receiver.
3. With a sharp object, press and hold the receiver’s reset
button until you hear one short and one long beeps.
Release the reset button after the second beep.
4. Within the subsequent 20 seconds, press the (small
fl
ame button ( ) on the remote handset until you
hear two short beeps con
fi
rming the synchronization
is set.
This is a one time setting only and is not required when
changing the batteries in the remote battery holder. The
remote control system is now ready to use.
Appliance’s
front panel
Check Operation
Turn the
fi
replace
fl
ame up and down using the
remote control to con
fi
rm that the full range of inputs
is achieved—see the remote control operation
instructions on pages 11–15.
Set Aeration
(if necessary)
Light the
fi
re and allow the unit to warm up for 11–15
minutes to evaluate the
fl
ame picture. The burner is
equipped with an adjustable shutter to control primary
aeration (NG only). The shutter is factory-set to an
aeration gap which will give optimum performance for
the vast majority of installations.
In a few unusual installations, the
fl
ame picture may
be improved by adjusting the aeration. The need for
adjustment should be determined only by operating the
appliance with the fuel bed and window installed.
Increasing aeration
will cause the
fl
ames to appear
more transparent and blue showing more ceramic
effects glow.
Decreasing aeration
will cause the
fl
ames to appear
more yellow or orange showing less ceramic effects glow.
Too little aeration may result in black carbon
forming and dropping into the fi rebox.
To access the air shutter, remove the front middle
platform as indicated. The air shutter is located under
the burner as shown in the illustrations. Loosen the air
shutter screw, adjust and re-tighten.
Air Shutter
Installation
QUALIFIED
INSTALLER
