36
strip
fl
ush
with studs
front face of
appliance
mounting
tabs (4)
Appliance’s
bottom strip
fl
ush to framing
Installation
Remove top outlet (6 screws)
Remove heat shield (3 screws)
Remove Heat Shield
Remove the heat shield from the top of the appliance
case (3 screws). If using the top outlet, discard the
shield. If using a rear outlet, keep the shield to reinstall
after converting the top to rear outlet—see next
subsection.
Convert Vent Outlet
(if required)
This unit is supplied with a top vent outlet which can be
fi
eld-converted to a rear vent outlet.
Please note that
the rear outlet requires the installation of the heat
shield on top of the heater case as indicated.
1. Remove the top outlet collar (6 screws).
2. Swivel the collar and install as a rear outlet (6 screws).
3. Reinstall the heat shield to the top of the appliance
case (3 screws).
Fit optional LDK Duct Kit’s take-off
collars to appliance
(if used)
See installation instructions packed with the LDK kits
for details.
Fit the Appliance into Framing
1. Remove the 4 screws retaining the engine to its pallet.
2. Taking great care not to
cut your hands on the
sheet metal edges, lift the
appliance out of its packing
base and place it in the
framing.
Make sure that
the unit is at the right height
with consideration to the
height of the hearth or
combustible fl ooring.
3. Fold out four mounting tabs and install the appliance
in the framing as shown.
4. Fasten the unit to framing using 4 screws or nails at
the mounting tabs.
Note:
The
sheet metal strip
at the bottom of the
appliance
must be
fl
ush with the framing studs.
Complete Installation of optional LDK
Duct Kit
(if used)
See installation instructions packed with the LDK kits
for details.
Swivel the outlet so
that it is oriented
towards the rear and
reinstall to heater
(6 screws)
Reinstall heat
shield to top of
appliance
(3 screws)
Rear outlet with required heat shield
QUALIFIED
INSTALLER