Valloy Incorporation Anytron Any-002, User Manual

Page: 65 / 68

Valloy Incorporation.
Any-002
User Manual
any-002 © 2015 Valloy Inc. All rights reserved.
Rev 1.0
– 2015.10
65 of 68
Please see HELP
for details
Open cover
Paper Jam Top
cover
Please see HELP
for details
Paper is caught
between the Tray and
the Black ID.
391~395:Error Check that paper is caught
between the vicinity of the
tray and the Y ID.
Check whether the Paper IN1
Sensor is normal. Yes
No Remove the paper caught.
Replace the IN1 Sensor.
Open cover
Paper Paper size
error TRAY
Please see HELP
for details Wrong paper size
detected (different by
45 mm or more from
the set value)
400: Error Is the paper of the user
designated size?
Is the paper of a standard
size? Yes
Yes
No No action is required.
Adjust the Tray Paper Guide.
Replace the Paper Size Plate (PXC
PWB).
Change Toner
COLOR Please
see HELP for
details Little Toner is left.
410: Y
411: M
412: C
413:K Isn’t there little relevant
toner?
Is the relevant Toner Sensor
normal? Yes
No Replace with a new toner.
Replace the relevant Toner Sensor.
Remove Paper
Stacker The paper discharge
tray is full. Is the discharge tray full of
paper?
Check the Stacker Full Sensor
of the Discharge Tray. Yes
No Empty the paper in the discharge
tray.
Replace the Stacker Full Sensor.
Insert paper MP
Tray MEDIA SIZE
Please see HELP
for details There is no paper in the
MP Tray, the unit is out
of the range, or the
printer is out of paper.
490: Error Check that there is not
enough paper in the MP Tray. Yes Put paper in the MP Tray.
Insert paper
TRAY MEDIA
SIZE Please see
HELP for details It is detected that there
is no paper in the Tray
1, 2, 3, 4, or 5.
491~495: Error Check whether there is paper
in the relevant Tray.
Check the No Paper Sensor
of the relevant Tray.
No Put paper in.
Replace the Sensor.
Replace Fuser The life of the fuser
counter is near its end. Check the life of the fuser and
replace the fuser.
Tray Paper
Almost Finished Insufficiency of paper
detected. Less than 30 sheets of the
supplied paper are left. Feed the paper.
Check the Near End Sensor.
File system
access error
<n>
901: Error
902: Error
903: Error
904: Error Recording in the HDD
not possible.
901: Short circuit
902: Disconnection
903: High Temperature
904: Low Temperature Isn’t the operation method
wrong?
Does the error occur again?
Yes Check the instructions in the
manual.
HDD failure, Replace the HDD.
Replace the Belt Thermister.
Turn on the power after 30
minutes.
SERVICE CALL
905:Error
906:Error Short Circuit of the
Prime Thermister Replace the fuser.
Replace the main board.
SERVICE CALL
907: Error
908: Error High Temperature Error
of Prime Thermister
(907)
Low Temperature Error Replace the fuser.
Replace the main board.