Valloy Incorporation.
Any-002
User Manual
any-002
© 2015 Valloy Inc. All rights reserved.
Rev 1.0
– 2015.10
51 of 68
- The fuser is located inside the printer just behind the four image drum units.
WARNING1: If the printer has recently been powered on, some fuser components will be very
hot.
Handle the fuser with extreme care, holding it only by its handle, which will only be mildly
warm to the touch. A warning label clearly indicates the area. If in doubt, switch the printer off
and wait at least 10 minutes for the fuser to cool before opening the printer cover.
WARNING2: If you need Fuser unit not used more than a month, you should keep it after
installing lock unit (orange color). If you don’t install lock unit and keep it more than a month,
the fuser roller can be modified.
1) Press the cover release and open the printer’s top cover fully.
2) Identify the fuser handle (a) on the top of the fuser unit.
3) Pull the two fuser retaining levers (b) towards the front of the printer so that they are fully
upright.
4) Holding the fuser by its handle (a), lift the fuser straight up and out of the printer. If the fuser
is still warm, place it on a flat surface which will not be damaged by heat.
5) Remove the new fuser from its packaging and remove the transit material.
6) Holding the new fuser by its handle, make sure that it is the correct way round. The retaining
levers (b)should be fully upright, and the two locating lugs (c) should be towards you.
