Valloy Incorporation.
Any-002
User Manual
any-002
© 2015 Valloy Inc. All rights reserved.
Rev 1.0
– 2015.10
28 of 68
- If you turn off and turn on the power, the sensor value is initialized.
2-1.2.2.1 How to use GAP pre-cut media
1.
- Black line that marked on plastic
guide of left photo, is guide for
sensor position.
Move the sensor guide line of
sensor to pre-cut media.
- Pay attention to the sensor guide
line should not be placed on
separated gap section of liner.
2.
- Press the SET button (1 second) to
select the sensing mode among
GAP, Front Black mark and Back
Black mark that user wants to.
- Select the GAP sensing mode
which is first one of left LED. (If
there was existing setting value,
initialize the value as pressing the
SET button of sensor for 5 seconds
before using.)
* Sensor initialization in case of
power ON/OFF
3.
- Press the SET button for 3 seconds
to enter the Auto Teaching mode.
- After pressing the SET button for 3
seconds, move the media up and
down to sensor detects the GAP.
- Sensing works normally if you hear
a Beep sound.
- At this time, press the SET button
one time to save the sensing value,
then sensor tuning is complete.
