Valloy Incorporation.
Any-002
User Manual
any-002
© 2015 Valloy Inc. All rights reserved.
Rev 1.0
– 2015.10
37 of 68
3-4.4 How to set printer driver for using pre-cut roll
- Width: Input width of paper
- Length: Input length of one label in pre-cut roll media to be printed
- Footer margin: Input length of vertical gap of paper to be printed
- Start: Input starting point of image to be printed
- Adjust mode: You have to select “Adjustable” without fail when using pre-cut roll media
3-4.5 Error correction
In ANY-002, two methods are used to correct error that may occur from software, i.e. “Full Bleed
method” and “1M Measurement method”. Error that left/right and top/bottom is twisted can be
corrected through “Full Bleed method”, however apart from this, if exact footer margin is not
inputted in driver, printed image may be going up or going down gradually.
3-4.5.1 Full Bleed
Full Bleed means a method to print image, enlarging width and length of image by 0.5mm~ 1mm.
When you use this method, software setting needs to be changed as below.
Direction of paper transmission