OMNIA
38
6.7.1.2
MATERIAL POSITIONING FOR DUAL SHEETS MODE
Note: The side of the sheets facing the front of the feeder can be min 200mm (7.87 ") wide and max
340mm (13.38") wide.
Note: in order to have the machine working at its best we recommend to have the two stacks of the
same height (materila quantity).
To run the dual sheets mode it is important to follow the below instructions to correctly load the materials. First of all
set Manual Mode (MAN) on the feeder (Figure 6-4) , than keep pressing the UP/DOWN selector on DOWN side lower
the loading work surface.
While positioning the material pay
attention to:
-
the side with a width between 200
and 340 mm, touches the front of the
feeder.
-
the left side touches the reference
plate (Point 0 nr. 1).
Then place the movable stops on the left
side and on the back of the material to
keep the material aligned eachother.
Warning:
Make sure to
do not position the
movable stops beyond the line drawn on
the surface (A), as they could interfere with
the reading of the photocells.
Place a movable stop facing the right side
in correspondence with the mark (B) on
the magazine.
Warning:
As we previously did, make sure
to do not position the movable stops
beyond the line drawn on the surface (A),
as they could interfere with the reading of
the photocells.
B
A
Figure 6-12
Point 0 (zero) nr.1
A
Figure 6-10
Figure 6-11
Summary of Contents for OMNIA
Page 1: ...OMNIA Instruction and Maintenance Manual...
Page 2: ......
Page 65: ......
Page 66: ...002695 rev 02...
