OMNIA
51
8.2
LUBRIFICATION
Cutting blade running guide (every 1 - 2 months
for all VersaTool cutting
heads type)
Remove the blade as previously described. Lubricate the guide at points (1)
and (2) with a small amount of spray grease taking particular care not to
allow any grease to reach the rubber roller. Carefully wipe off all excess
grease before re-inserting the cuttting blade. It is absolutely essential that
you do not allow any lubricant to come into contact with the rubber roller.
CAUTION!
Use only a teflon based lubricant. Avoid using
conventional oils as they can cause an accumulation of dust
and paper dust scraps on the cutting head guides and could
leave traces of oil on the material being cut.
Maintenance of Lifting system of Material loading table (every 1-2 months)
•
Open the magazine door with the special keys.
•
•Check that the cylinder rod (1) and the lifting screw (2) are well greased and clean, otherwise clean and refill
grease in the cylinder (1) through the grease nipple (3) and manually apply the same grease on the whole screw.
•
Close the door, set the left selector to “MAN” mode and holding the right selector (left and right) move the loading
table up and down (Figure 6-4) to spread the grease.
Note.
Pay Attention that there is nothing that can prevent the movement of the loading table.
•
Open the door and make sure that everything is well greased.
•
Close the door with the key.
Figure 8-2
1
2
1
2
3
Figure 8-3
Summary of Contents for OMNIA
Page 1: ...OMNIA Instruction and Maintenance Manual...
Page 2: ......
Page 65: ......
Page 66: ...002695 rev 02...
