OMNIA
41
6.7.4
OSCILLATING CUTTING TOOL PREPERATION (OPTIONAL)
DANGER:
Use protective gloves is strongly recommended, be very careful as the pressure of the moving
part (2) could cause the blade exit.
•
Loosen the locking set screws (1) and remove the movable blade guard (2).
•
Loosen the blade holder screw (3) and insert a new “TC” Type blade, paying attention that the blade notch (4)
matches the locking screw and then push it inside until to the stop and tighten the screw (3).
•
Position the blade guard (A) or (B), depending on whether we have chosen a TC5/10/15 or TC25 type, paying
attention that the reference pin fits into its housing (5), then grab it from the sides (6) and push it towards the
tool.
Attention:
while inserting the blade protection, pay attention the palm of your hand is not positioned in front of the
tool as indicated by the prohibition symbol.
•
Tighten the locking set screws (1).
Figure 6-16
1
2
3
4
TC25
TC5/10/15
6
6
5
6
5
A
B
TC5/10/15
TC25
Summary of Contents for OMNIA
Page 1: ...OMNIA Instruction and Maintenance Manual...
Page 2: ......
Page 65: ......
Page 66: ...002695 rev 02...
