OMNIA
26
•
Guide the loader to the machine, taking care to align it with the marks on the back of the machine.
Figure 5-16
•
Adjust the feet on the door side so as to match the rear of the machine with the front of the loader (if the loader
touches at the top, but is distant at the bottom, screw in the feet; if the situation is opposite, unscrew the feet
until perfect alignment is obtained between the rear of the machine and the front of the loader).
•
Couple the loader with the machine by screwing and tightening the 6 screws removed previously (Figure 5-14).
•
Remove the two screws from the transmission protection supports.
Figure 5-17
•
Refit the transmission 1 protection (under the side protectors), block everything with the screws previously
removed.
Figure 5-18
Screw the two anchoring brackets 2 & 3 on the front of the machine with the 4 screws and washer supplied
The marks
and
drawn on the back of
the machine must match the outline of the
loader.
Move the loader using the forklift truck to
align it left or right, and then adjust the
side feet to align the height.
1
Summary of Contents for OMNIA
Page 1: ...OMNIA Instruction and Maintenance Manual...
Page 2: ......
Page 65: ......
Page 66: ...002695 rev 02...