Valiani OMNIA, Instruction And Maintenance Manual

Page: 26 / 66

OMNIA
22
Once the arm has been repositioned in the working position, remove the blocks of the beam and the head as described
below:
Insert the 16 mm open key supplied in the groove of the locking pin (1) to keep it still, at the same time use the 19 mm
open key supplied to unscrew the locking screw (2).
Move the beam by pushing it forward in order to free the locking pin (make sure that the casing does not remain hooked
to the pin while moving, if necessary, pull the casing slightly upwards to facilitate its passage over the pin).
With the aid of the 16 mm key unscrew the pin (1) until it is released from the base Figure 5-8.
Remove the head block (3) by unscrewing the two fastening screws (4) with the wrench supplied Figure 5-9.
1
2
1
4
3
Figure 5-6
Figure 5-7
Figure 5-8
Figure 5-9