Valiani OMNIA, Instruction And Maintenance Manual

Page: 53 / 66

OMNIA
49
7.3 ADJUSTING THE DOWN PRESSURE OF THE CUTTING HEAD
To cut special hard materials, or to avoid the wheel on the cutting head leaves a mark on soft materials, it may be
necessary to adjust the pressure of the air in the cylinder controlling the head down pressure. Adjustment can be made
as follows:
Remove the protection glass by unscrewing the four locking screws (A). Pull knob (1) out (on) for a short distance to
release the pressure regulator. Turn the knob (1) until it reaches the pressure necessary for the blade head to operate
correctly. When the correct pressure is reached push the knob (1) home to lock in place (OFF)
, then reassemble the
protection glass with the four screws removed previously.
To perform a Kiss cut with VersaTool, the switch (K) must activate by moving into KISS-CUT ON mode (K).
7.4 ADJUSTING THE UNLOADING CHUTE INCLINATION.
Based on the materials to be processed and their dimensions, it may be appropriate to adjust the inclination of the
discharge chute.
To change the inclination, simply loosen the two knobs
on the sides of the slide, adjust it to the desired height
and re-tighten the knobs.
NOTE! We suggest that you adjust the pressure in a range between 0.3 and 0.5 bar depending on the
thickness of the materials to be processed.
When you finish a kiss-cut, turn the switch (K) to KISS-CUT OFF mode before performing any other
processing to avoid damage to the work table
1
K
A
Figure 7-3
Figure 7-4