UTC Fire and Security Kidde AirSense SynaG Series, Installation Manual

Page: 22 / 104

Chapter 2: Installation
16 SynaG Series Installation Manual
Connecting supervised outputs
Control panels have the following supervised outputs:
• Two-zone control panels have two outputs, marked OUT1 and OUT2.
• Four- and eight-zone control panels have four outputs, marked OUT1, OUT2,
OUT3, and OUT4.
The outputs are supervised for open and short circuit faults.
Output class
The control panel outputs can be configured for Class A or Class B operation,
depending on the supervision mode required. The default output configuration is
Class B.
Table 11: Output classes and EN 54-13 supervision
Output class EN 54-13 supervision Description
Class B (default) Disabled For installations not requiring EN 54-13
compliance
Class A Enabled For installations requiring EN 54-13
compliance
For more information, see “EN 54-13 supervision mode” on page 34.
Output functionality
The function of each output is defined by the panel operating mode and output
class configuration (the default is Class B). All outputs are overload protected.
Table 12: Class B output functionality (default)
Operating mode OUT1 OUT2 OUT3 OUT4
EN 54-2 Sounders Sounders Sounders Fire routing
EN 54-2 Evacuation Sounders Sounders Sounders Sounders
EN 54-2 Scandinavia Sounders Sounders Sounders Fire routing
BS 5839-1 Sounders Sounders Sounders Sounders
NBN S 21-100 Evacuation
sounders Evacuation
sounders Warning
sounders Warning
sounders
NEN 2535 Sounders Sounders Fire routing
(automatic)
Fire routing
(manual)
Table 13: Class A output functionality (for EN 54-13 compliance)
Operating mode OUT1/OUT2 OUT3/OUT4
EN 54-2 Sounders Fire routing
EN 54-2 Evacuation Sounders Sounders
EN 54-2 Scandinavia Sounders Fire routing