Chapter 3: Configuration and commissioning
SynaG Series Installation Manual
25
The user interface
Consult the operator manual for details on the different controls and indications
provided by the control panel.
User interface for two- and four-zone control panels
Figure 16: User interface for two- and four-zone control panels
Legend
1. Zone buttons and LEDs (Z1, Z2, etc.)
2. Supply
LED
3. General Fault LED
4. General Fire Alarm LEDs
5. Sounder Fault/Disable/Test button and
LED
6. Sounder Delay button and LED [2]
7. Networking Fault LED
8. Reserved for special use [2]
9. Expansion I/O Fault/Disabled LED
10. General Disable button and LED
11. General Test button and LED
12. Configuration controls
13. Reset button and LED
14. Panel Silence button and LED
15. Sounder Start/Stop button and LED
16. System Fault LED
17. Out of Service LED
18. Earth Fault LED
19. Supply Fault LED
20. Fire Routing Delay button and LED [1][2]
21. Fire Routing ON/ACK and
Fault/Disable/Test button and LEDs [1][2]
Notes
[1] Two-zone control panels do not support fire routing or warning sounders for NEN 2535.
[2] Regional variants include changes to interface buttons and LEDs. See Table 16 on page 27.
Summary of Contents for Kidde AirSense SynaG Series
