Chapter 2: Installation
SynaG Series Installation Manual
21
Connecting expansion boards
Caution:
Risk of equipment damage. Always disconnect the control panel from
the mains power supply before installing an expansion board.
See your expansion board installation sheet for detailed installation information.
Connecting a fire network
Note:
See the
2010-1-NB Network Board Installation Sheet
for detailed
installation and connection information.
Each 2010-1-NB network board has two ports. Each port is connected (point to
point) to the corresponding ports of the network board in another control panel.
Figure 13: Network board connections
Two wiring options are possible:
• Ring
configuration
• Bus
configuration
Ring configuration
Ring network configuration is recommended as it provides for redundancy in the
transmission path.
For ring configuration (Class A), use both ports to connect all network boards or
control panels to form a ring, as shown below.
Summary of Contents for Kidde AirSense SynaG Series
