Appendix A: Configuration presets
SynaG Series Installation Manual
87
Display Event Output Delay
Display Event Output
Delay
25 Fault
1-4
No
2 No
26 Alarm
1-2
No
Reset
on
3 No
Fault 3-4 No
4 No
27 Alarm
1 No
34
[2]
Fire
Routing
(Auto)
1 No
Fault 2
No
2 No
Buzzer on 3
No
Fire routing
(Manual)
3 No
Reset 4
No
4
No
29
Fault [1]
1-4
No
35 [2]
Fire routing 1
No
30 Alarm
1-2
No
2 No
Fault [1]
3-4
No
Fault
warning
output [3]
3 No
31 Alarm
1 No
Fault
[1]
4 No
Fault [1]
2
No
36 [4]
Remote
RB/SBx.01
output
activation
[4]
1 No
Buzzer on 3
No
Remote
RB/SBx.02
output
activation
[4]
2 No
Reset on 4
No
Remote
RB/SBx.02
output
activation
[4]
2 No
32 [2]
Fire
protection
1 No
Remote
RB/SBx.04
output
activation
[4]
4 No
2 No
Fault
warning
output [3]
3 No
Fault [1]
4
No
[1] Fail-safe mode: output is active when there is no fault.
[2] These presets are only available for 2010-1-SB supervised expansion boards.
[3] NEN 2535 only. Fault warning output open supervision (subject to input configuration).
[4] RB/SBx is the expansion board x. For two-zone and four-zone panels, x can be 1 or 2. For
eight-zone and evacuation panels, x can be 1, 2, 3 or 4.
Configuration 36 is only possible when the Network Remote Output Control option (nO) is set
and it is then configured by default.
Summary of Contents for Kidde AirSense SynaG Series
