DS1068-020B
43
LBT20769
8.4
REMOTE CONTROL WITH GUIDED VOICE MENU
The remote control call can be made from a landline with tone keypad (DTMF) or a mobile phone. The PSTN
*
or GSM answering
machine must be enabled to uses all functions. If you want to use the PSTN
*
answering machine, you must program the parameter
"Incoming PSTN
*
rings" to a value greater than zero. If you want to use the GSM, you must program the parameter "Incoming GSM
rings" to a value greater than zero.
PSTN
*
= available only with 1068/005 control panel.
8.4.1
Calling the PSTN answering machine in the absence of an answering machine (available only with
1068/005 control panel)
Call the PSTN number of the control panel and wait for a number of rings equal to the value programmed for the parameter "Incoming
PSTN rings". This parameter should be programmed to a value greater than zero.
8.4.2
Calling the PSTN answering machine with an answering machine available (available only with 1068/005
control panel)
The answering or fax machine must be set to pick up after at least two rings in order to be able to call the PSTN answering m achine
when on the line there are an answering or fax machine. You must also set the "Incoming PSTN rings" parameter to a value higher
than the answering machine's value.
The PSTN answering machine can be called as follows:
1) Call the control panel and hang up after the first ring. The control panel will detect the incoming call without picking up because
the number of rings is lower than the set number.
2) Call the control panel back within 30 seconds.
3) The control panel will immediately engage the line after the first ring without counting the number of programmed rings. In this
manner, the telephone answering machine or fax will receive only one ring and will engage the line instead of the control panel.
8.4.3
Calling the GSM answering machine
Call the GSM number of the control panel and wait for a number of rings equal to the value programmed for the parameter "Incoming
GSM rings". This parameter should be programmed to a value greater than zero.
8.4.4
Functions of the guided voice menu
The guided voice menu can be used to: set zones, unset zones, switch commandable outputs, isolate and enable inputs, query
system status.
The system status summary sends vocal messages about: active zones, tampering or system failure status.
Proceed as follows for remote control:
1) Call the PSTN
*
or GSM phone number of the control panel from a landline or mobile phone.
2) Enter the valid code within 10 seconds on the keypad at the prompt. Enter a digit and wait for the confirmation beep before
entering the next one.
Enter “#” at the end of the digits.
3) You will hear a welcome message if the entered message is correct. Otherwise, try to enter the code again (up to three attempts).
4) After having been recognised you have a few seconds to enter the menu number (see
Table of List of DTMF commands
) and
access the required menu directly. Otherwise, follow the vocal menu instructions to access and use the various functions.
5)
Press “
*
“ repeatedly to exit remote control.
IMPORTANT!
In remote control mode, the
*
(asterisk) key will allow you to go back to the previous menu.
PSTN
*
= available only with 1068/005 control panel.
