DS1068-020B
42
LBT20769
8
USER REMOTE CONTROL
8.1
ACTIVATION AND DEACTIVATION OF OUTPUTS WITH SMS
Outputs programmed as “commandable” can be activated or deactivated remotely by sending SMS messages. The "Incoming SMS"
GSM parameter must be enabled to use this function. Furthermore, the text message must come from a known phone number, i.e.
one of the 12 phone numbers stored on the control panel.
IMPORTANT!
This number does not need to be associated to an event.
In order for the control panel to recognise the phone number, remember to save it with the international prefix (for
example 0039 for Italian numbers).
The text message to be sent to the phone number of the SIM Card of the control panel must have the following syntax:
2nns.
where:
nn
is the logical number from 01 to 10 of the commandable output or commandable pulse to be switched;
s
is a digit which represents the status that the output must assume:
1
(set) or
0
(unset). In case of pulsed commandable
output only
1
(set) can be used;
.
(full stop) is the end of the message.
Several controls can be queued in the same text message and separated by a comma. The text message must end with a full stop
(“.”).
Any spaces will be ignored, but characters other than digits, spaces, commas and full stops will be considered errors. The text
message will be rejected.
EXAMPLES
SMS
Description
2031.
Correct: this message will activate logical output 03
2 03 1.
Correct: this message will activate logical output 03
2031, 2050.
Correct: this message will activate logical output 03 and deactivate logical output 05
2031
Wrong: no full stop at the end of the message
2 3 1.
Wrong: the output number is not written using two digits
2031. 2050.
Partially correct: the first command will be executed, the second one will be rejected.
The co
ntrol panel will send a reply text message with the received message text and “OK” or “KO” to confirm command reception.
EXAMPLE: Command
2031.
–
Reply
: 2031 OK. Otherwise the reply will be "2031 KO".
8.2
DEVIATION OF INCOMING SMS MESSAGES
SMS messages that are not recognised as commands can be deviated to a number in the directory by configuring the GSM parameter
"SMS deviation number". The SMS can also come from numbers not present in the directory
If the GSM parameter "incoming SMS" is disabled, the commands are also deviated.
8.3
ACTIVATION OF OUTPUTS WITH FREE OF CHARGE CALLS
The outputs programmed as "commandable" can be activated remotely by means of a phone call without the caller being charged any
cost. To use this function, the GSM answering machine must be enabled and the outputs that can be controlled must be associated
with a known phone number, i.e. be part of the 12 phone numbers saved in the control panel.
IMPORTANT!
The same phone number may command multiple outputs. One output cannot be commanded by multiple phone
numbers.
In order for the control panel to recognise the phone number, remember to save it with the international prefix (for
example 0039 for Italian numbers).
The operating principle is the following:
1) The GSM number of the control panel is called using the phone number saved in the control panel.
2)
The call is closed within the number of rings defined by the "incoming rings” GSM parameter.
3) All the associated commandable outputs are activated: the pulsed ones for the time configured (typical application of a gate
opener), commutable ones or bistable ones until they are deactivated by sending the relative command via SMS.
4) To confirm reception of the command, the control panel calls the number that originally called for a few seconds, confirming the
command made (eventually you must not be answered in order to avoid having the cost charged to the control panel SIM card).
