Universal Laser Systems PLS3.60, Safety, Installation, Operation, And Basic Maintenance Manual

Page: 39 / 116

GRAPHICS SOFTWARE SETUP
Section 3-9
10. The rulers on screen need to match the rulers in
the PLS. Adjust the ruler's vertical origin by
double-clicking directly on the vertical (side) ruler.
The “Options” dialog box will appear. In the
vertical origin box, type in the length of the vertical
ruler of your PLS. In this example the vertical ruler
is 12 inches. Click OK.
11. Set the default value for line width and color of the graphic
objects, by clicking the outline tool (1) and then the outline
pen dialog in the flyout (2). With “Graphic” being the only
selection checked, click “OK”. Click the down arrow in the
Color dropdown box to expand the list and click on the color
RED . Click the down arrow in the “Width” dropdown box
and click “Hairline”. The units can be “inches”, “millimeters”
or anything else you prefer. Click OK to close the Outline
Pen dialog box.
12. In the top menu, click “
Tools ”, and then click
“ Color Management ”. Click on the down arrow to
expand the “ Style ” dropdown list. Click “ Color
Management Off ”, and then click “ OK ”.
13. Finally, at the top of the screen, click on “Tools”,
then “Options”, then “Document”, and then select
“Save Options as Defaults for New Documents”.
Make sure
ALL the options listed are CHECKED
then click “OK”.
14. The setup defaults for CorelDRAW 12 are now complete. Whenever you start a new document, all of
the default settings that we had setup will automatically apply to the new document.
Remove the Software Installation CD-ROM from your CD-ROM drive and store it either back into
the pocket of the rear cover of the manual or in a safe place.
Next proceed to section 4 for laser system
assembly.