© 2023 Breckwell
17
MAINTENANCE
“ON” button with the viewing door open). Vacuum out the
hopper. Thoroughly clean the burn pot, and firebox. It may
be desirable to spray the inside of the cleaned hopper with
an aerosol silicone spray if your stove is in a high humidity
area. The exhaust system should be thoroughly cleaned.
MAINTENANCE SCHEDULE
CAUTION:
THIS WOOD HEATER NEEDS PERIODIC INSPECTION
AND REPAIR FOR PROPER OPERATION. IT IS AGAINST
FEDERAL REGULATIONS TO OPERATE THIS WOOD
HEATER IN A MANNER INCONSISTENT WITH OPERATING
INSTRUCTIONS IN THIS MANUAL.
Use the following as a guide under average use conditions.
Gaskets around door and door glass should be inspected
and repaired or replaced when necessary.
Daily
Weekly
Monthly or
as needed
Burn Pot
Stirred
Empty
Combustion Chamber
Brushed
Ashes
Check
Empty
Interior Chambers
Vacuumed
Combustion Blower
Blades
Vacuumed
/ Brushed
Convection Blower
Impeller
Vacuumed
/ Brushed
Vent System
Cleaned
Gaskets
Inspected
Glass
Wiped Cleaned
Hopper (end of season)
Empty &
Vacuumed
INSTRUCTIONS SPECIFIC FOR CANADIAN INSTALLATIONS
Do not obstruct the space under the heater and do not
obstruct the combustion air openings.
Refer to the chimney manufacturer’s instructions for
disassembling the chimney/venting for transportation of a
transportable building.
The parts or materials to be employed for ember protectors
and the minimum areas to be covered and their relation
to the space heater, as well as the notice: “In Canada, to
comply with CSA B365, Installation Code for Solid-Fuel-
Burning Appliances and Equipment, any combustible
covering beneath the appliance and/or within the area
extending horizontally at least 450 mm (18 in) beyond the
appliance on any side equipped with a door, and at least
200 mm (8 in) beyond the appliance on other sides, shall
be protected by a continuous, durable, non-combustible
pad that will provide ember protection. The 450 mm (18
in) ember protection required on any side with a door shall
extend for the full width of the appliance plus the 200 mm
(8 in) required on each side of the appliance without a
door. Where an appliance is installed less than 200 mm (8
in) from a wall, the ember pad need only extend to the base
of the wall. An ember pad shall not be placed on top of a
carpet unless the pad is structurally supported to prevent
displacement and distortion.
If this appliance is installed in a transportable building,
removal of the chimney/venting is required for transportation
of the building.
DO NOT INSTALL IN AN ALCOVE
DO NOT INSTALL IN ANY FIREPLACE
Summary of Contents for SP1000E
