Unipro UniGo One kit 1, User Manual

Page: 21 / 56

21
C o n f i g u r i n g
t h e L a p t i m e r
Configuring the Laptimer
This chapter will learn you all about the configuration of UniGo One.
Entering setup, most often settings, and every single setting.
A correct setup is essential for the maximum performance of your
Laptimer so make sure to read this chapter carefully.
You will be ready to go in 5 minutes...
ENTER SETUP MODE
You enter the Setup menu directly from the
rolling menu. UniGo One have two different
setups indicated by the following icons:
Simple setup. Only often used settings.
Advanced setup. All available settings.
When entering setup you will see the setup
menu as shown below. Here you will find
all settings divided into different collections.
These collections are explained in this chapter.
A collection is by default collapsed. This way
it is very fast to move between the different
collections.
The advanced setup contains different
collec tions of settings.
If you want to expand a collection you simply
press the
expand button ( ).
The event collection is expanded to show
the settings.
Two new buttons are now visible. To collapse
the collection again, press the
collapse button
( ).
GENERAL SETUP FEATURES
In Setup mode you use the
up ( ) and down
( ) buttons to move around in the menu and
press the
edit button ( ) on the relevant line
to change the value. To accept the changes
press the
ok button ( ) again or press cancel
( ) to cancel the changes and revert to the
original value.
If a menu line is ending with “:” it means the
value can be changed directly by pressing the
edit button ( ). If the line is ending with ( )
it will go into another screen, and finally a line
ending with ( ) will expand another menu.