13
RUNNING CABLES
The installation of the Laptimer should be seen
as a permanent installation on the go-kart and
the time to run the cable in a nice way is time
well spend.
Cable fixed to frame. Run RPM wire sepa-
rately.
Use plenty of cable ties and make sure to use
nice soft bends on the cable. When tightening
the cable ties, make sure not to tightening
them too hard to avoid squeeze the cable.
Cable fixed to the frame with cable ties.
Running the cables from the Laptimer on the
steering wheel is the biggest challenge. The
cable need to be mounted in a way that the
steering wheel can be moved freely.
Cable fixed to the frame with cable ties.
Attach the cables together with a cable tie
and attach the bundle to the steering column.
Make a soft bend with a suitable length and
check the steering wheel have total freedom
in turning. The cables should not pull at the
connectors when turning and no sharp bend
should be allowed.
Professional installation will ensure profes-
sional results.
SPLITTERS
Cable splitters are used to increase the
number of sensor that can be connected to the
Laptimer.
I n s t a l l i n g t h e
L a p t i m e r
Installation
Summary of Contents for UniGo One kit 1
