12
UniGo mounted at the correct distance to
the steering wheel.
Before tightening the nut, make sure that all
the cables can be connected without conflict-
ing with the steering wheel or other obstacles.
CONNECTING RPM WIRE
The RPM wire is used to pick up the engine’s
revolution count by sensing the pulses on the
ignition cable going from the ignition coil to
the spark plug.
The ignition is a very noisy signal and extra
care should be paid on installing the RPM
wire.
The wire can be removed from the Laptimer
and attached again if needed. It is simply a
wire going through two holes with a loop.
Run the RPM wire away from other cables.
To make the best possible installation, keep
the RPM wire away from all other cables.
RPM wire attached with cable ties.
The RPM wire needs to run all the way from
the Laptimer to the engine on the back.
Secure the wire all the way with cable ties.
The RPM wire is running alone all the way
to the ignition.
RPM wire mounted to pick up the ignition
signal from the ignition wire.
The RPM wire is attached to the ignition cable
in a way that gives a good pick up of the sig-
nal. Twist the wire around the cable and make
a loop at the end like shown on the picture.
Installation
I n s t a l l i n g t h e
L a p t i m e r
Summary of Contents for UniGo One kit 1
