Uninterruptible Power Supplies PowerWAVE 8000DPA RI, User Manual

Page: 65 / 76

UPS338-01-00 PowerWAVE 8000-RI DPA User Manual Dated 5 April 2013
7-1
7
Options
7.1 Introduction
The PowerWAVE 8000-RI DPA UPS has the following available options:
• Remote Emergency Stop facilities
• Generator On facilities
• 1 x Customer-input functions (customer defined)
• WaveMON shutdown and management software
• SNMP Card for network management and remote monitoring
• Modem/Ethernet interface for NewWatch™ management software
7.2 Remote Emergency Stop
The remote emergency stop facility must use a normally-closed contact which opens to operate the
emergency stop sequence.
Usually the remote emergency stop function is disabled, and it should be activated by a hardware code on
the SETUP SERVICE menu. Please contact your distributor to enable this operation.
The remote shutdown facility is connected to terminal port X1/7 – X1/8 on the communication card located n
the PowerWAVE 8000-RI DPA front frame.
In order to allow removal, maintenance or testing of any remote emergency stop facility, without disturbing
the normal operation of the UPS, it is recommended that a terminal block, with linking facilities, is installed
between the UPS and the remote emergency stop button.
1. Use a screened cable with 1 pair (section of wires 0.6 mm2) and maximum length of 100 m.
2. Connect the cable as shown in Figure 7.1.
Figure 7.1 Remote Emergency Stop cabling
X1
X1/7
X1/8
Remote shutdown
Terminal block
UPS Remote
Shutdown Port
X1