Safety and Regulatory Instructions
c02_WL3.fm
Regulatory Compliance Statements (USA and Canada only)
A31003-M2000-U107-1-7619, 1/2017
18
WL3 and WL3 Plus WLAN Handset, User Manual
2.3 Regulatory Compliance Statements (USA and Canada only)
2.3.1 FCC and IC Compliance Statements
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la Classe B conforme á la norme NMB-003 du
Canada.
Privacy of communications may not be ensured when using this handset.
2.3.2 Exposure to Radio Frequency Signals
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This device complies with FCC SAR limit of 1.6 W/kg.
The maximum SAR value measured when used at the ear is 1.38 W/kg. The
telephone has also been tested when worn on the body using belt clip. The
maximum measured SAR value in this configuration is 1.16 W/kg. This device
must not be co-located or operating in conjunction with any other antenna or
transmitter.
Use of non-Unify approved accessories may violate the FCC and IC guidelines
for RF exposure and should be avoided.
FCC ID: BXZWH1
IC: 3724B-WH1
US: 9FVIPNANWH1
HAC