Page 19
Version 3.3 / November 2016
•
Turn ON the vending machine and wait till the stack of cups falls into the dispenser following the
automatic rotation of tubes and the rotation of tubes stops.
• Make sure that the lowest cup (first to fall) in the new stack is strictly vertical (without any bends or
tilts). If there is any vertical tilt, please adjust it by raising the stack from below and then replacing it.
•
Add cups to the rest of the vacant tubes and replace the lid.
Figure 31а
Figure 31б
NOTE: To install the tubes on the cup dispenser
mechanism, turn aside the spring (see figure 30b)
and install the tubes (see figure 30c).
ATTENTION:
Incorrect installation of tubes (see fig
-
ure 30d) can damage the dispensing mechanism! It
is strictly prohibited to rotate the tubes manually, be-
cause this would damage the tubes’ rotation mecha-
nism!
3.4.6 Spoon dispenser (see figure 29)
The spoons are dispensed in accordance with the configurations of the service menu. You can turn OFF
the dispensing of spoons or only turn it ON for drinks with added sugar.
Figure 32
Figure 33
Figure 34
The dispenser can be refilled from the top (see figure 32).
Place the spoons in the dispenser’s column without packing
(see figure 32), then place the two metallic weights on top
of the spoons.
These weights are supplied with the vending machine.
The dispenser can hold spoons of the following three
lengths: 95mm, 105mm, 115mm.
The dispenser’s maximum capacity is 600 spoons.
The vending machine comes with the dispenser set for
105mm spoons.
To adjust it for spoons of 95mm or 115mm, please adjust the
guide, as shown in figures 33 and 34.
30а
30b
30c
30d
