ULTRA SECURE
www.ultrasecuredirect.com
24
Advanced settings
Change the password
All SMS commands begin with the password (
4 digits
) followed by a #. This is
therefore essential. By default, the password is 1234. You can change it using the
following command:
1234#P#XXXX
Variable data
Meanings
1234
Current password (
1234 if default password never changed
).
XXXX
New password (
4 digits
).
Receive device status report
You have the option of receiving a status report containing general information on
your UltraCOM 4G (
listed in the table below
).
YYYY-MM-DD HH:MM
Date and time
SIGNAL: XX/31 (4G)
Signal quality from 1 to 31, see network status
table (
page 30
) and network type (
2G/3G/4G
)
DND: ON/OFF (ACTIVE/INACTIVE)
“Do not disturb” mode status (
enabled or not
)
R1:
Relay 1 open state
R2:
Relay 2 open state
SIM: 0234567890
Number of the SIM card
IMEI: 112233445566778
IMEI number
ULTRACOM 4G vYYYYMMDD/YYYYMMDD Hardware and software release dates
Important: The sample commands listed in this manual use the default
password 1234. If you change your panel's password, remember to use
the new password for your SMS commands.
To confirm the command, the UltraCOM 4G sends you a reply SMS. If this
SMS contains an error message (
ERR:
), refer to the error response table
(
see page 30
) to identify the cause.
If you forgot your password, you need to perform a manual panel reset (
see
page 26
).
