UBI EasyCoder 501 – Service Manual
30
Continued!
Installation, Rear Guide Shaft:
The rear guide shaft is already fitted on all printers equipped with
a paper rewind kit, see chapter 9. However, in this case there are no
guide rolls on the shaft. Just press two guide rolls onto the shaft, as
illustrated below. You will need to bend the shaft slightly away
from the bottom plate before you can fit the inner guide roll.
If there is no rear guide shaft already fitted in the printer, use one of
the shafts included in the kit and attach it to the printer's centre-line
wall by means of a #T20 Torx screw (included) inserted from the
electronics compartment as illustrated below.
Before removing the left-hand cover, read the instructions in
chapter 1.1.
Adjust the inner guide roll so it guides the paper exactly 20 mm
(.79") from the printer's centre-line wall. Then adjust the outer guide
roll according to the width of the paper.
5.2
External Supply, cont'd.
5. PAPER SUPPLY, cont'd.
20 mm
(.79")
