UBCO 2x2 ADV Gen 5, Technical & Service Manual

Page: 98 / 159

UBCO TECHNICAL SERVICE MANUAL PAGE 98 OF 159
2. Using a 5mm Allen Key, loosely tighten the Handlebar End Cap fastener,
attaching the Lever Guard to the Handlebar while ensuring the Lever Guard is
angled as shown.
3. Using a 5mm Allen Key , loosely tighten the fastener connecting the Lever
Guard to the Bar Clamp
4. Using a 5mm Allen Key Socket and Torque Wrench , first set the angle of the
Lever Guard to the desired position then tighten the Handlebar End Cap fas -
tener
5. Using a 5mm Allen Key Socket and Torque Wrench , first tighten the fastener
attaching the Lever Guard to the Bar Clamp then the Bar Clamp to the Han -
dlebar
6. Test to ensure the Throttle turns and releases freely, if this does not occur fol -
low the steps below;
7. Using a 3mm Allen Key , release and loosen the Throttle Grub Screw and move
the Throttle approximately 2-3mm axially towards the Dash . Tighten the
Throttle Grub Screw.
8. If the Throttle is still not moving freely, undo this process to step 2, installing a
M8 Spring Washer between the End Cap and Handlebar