UBCO 2x2 ADV Gen 5, Technical & Service Manual

Page: 155 / 159

UBCO TECHNICAL SERVICE MANUAL PAGE 155 OF 159
PRE-REQUISITE STEPS
Wheel Removal - Page 48 or Page 50
REMOVE
1. Using a Heat Gun and T20 Torx Key , remove the 3 Heatsink fasteners and
Heatsink
2. Using a Heat Gun and T25/T20 Torx Key , release and remove the 9 Motor fas -
teners and Motor Side Cover
3. Release and remove the Motor Core from the Motor Case , you may need to
gently tap the brake side of the Motor Axle on a table to release
4. Discard the Motor O-Ring , Small Motor Seal and Large Motor Seal
REPLACE
1. Remove all old lubricant and thoroughly clean the Motor Case
2. Apply ROCOL FOODLUBE Premier 1, EP1 Grease to the Annulus Gear
3. Ensure the Wave Washer is fitted to the Motor Axle
4. Using a 10mm Spanner , rotate the Motor Axle to allow it to fully seat in the
Annulus Gear
5. Apply Red Rubber Grease before installing new Motor O-Ring, Small Motor
Seal and Large Motor Seal
6. Applying even pressure, assemble the Motor Side Cover onto the Motor Hous -
ing
7. Using Loctite 243, T25/T20 Torx Socket and Torque Wrench , tighten the 9
Motor fasteners
8. Using T20 Torx Socket and Torque Wrench , tighten the 3 Heatsink fasteners