UBCO 2x2 ADV Gen 5, Technical & Service Manual

Page: 150 / 159

UBCO TECHNICAL SERVICE MANUAL PAGE 150 OF 159
REMOVE
1. Using a 4mm Allen Key , loosen the 2 fasteners attaching the Cable Clamp to
the Fork
2. Disconnect the Motor Cable from the Motor Controller and Front Motor
3. Using a 5mm Allen Key and 10mm Spanner , remove the fastener attaching the
P Clip to the Front Carrier
4. Using Flush Cutters , remove any Cable Ties holding the Motor Cable to the RH
Cable Bundle
REPLACE
1. Thread the Motor Cable into place through the Front Console Rear Cover
2. Using a 4mm Allen Key Socket and Torque Wrench , tighten the 2 fasteners
attaching the Cable Clamp to the Fork
3. Using a 5mm Allen Key Socket , Torque Wrench and 10mm Spanner , tighten the
fastener attaching the P Clip to the Front Carrier
4. Connect the Motor Cable to the Motor Controller and Front Motor
5. Gather the bundle of cables released within the remove stage and Cable Ties
together
6. Test to ensure the motion of the Handlebar is not restricted in any way by the
Right Hand Cable Bundle