UBCO 2x2 ADV Gen 5, Technical & Service Manual

Page: 30 / 159

UBCO TECHNICAL SERVICE MANUAL PAGE 30 OF 159
14. OPTIONAL - If replacing the Brake Fluid - Slowly press the syringe until the
colour of the fluid in the Bleed Kit Funnel changes slightly lighter. This means
that all of the fluid has been replaced with the new lighter fluid
15. Remove the Syringe from the Caliper
16. Using a 3mm Allen Key , lightly tighten the Caliper Bleed Screw
17. Actuate the Brake Lever Blade 10 times
18. Move the Handlebar into a position so the Master Cylinder is approximately
horizontal
19. Actuate the Brake Lever Blade 10 times or until air bubbles stop being
released into the Bleed Kit Funnel
20.Repeat Steps 6, 7, 8, 10, 11, 14 and 15
21. Actuate the
Brake Lever Blade until resistance is firm. If this does not occur,
repeat the whole process.
22. Using a 3mm Allen Key Socket and Torque Wrench , tighten the Caliper Bleed
Screw
23. Remove the Bleed Kit Funnel and replace with the Master Cylinder Bleed Port
Screw
24.Using a 3mm Allen Key Socket and Torque Wrench , tighten the Master Cylin -
der Bleed Port Screw
25.Using Isopropyl Alcohol and a Lint Free Cloth , clean both the Master Cylinder
and Caliper thoroughly.
26.After re-installing the Brake Pads and Wheel the Caliper may need adjusted
using the method outlined on Page 31