17
EMP
Installation & Service Manual
109529-03 - 11/19
Step c.
Remove three (3) 5/16-18 x 3/4 lg.
cap screw from burner swing door used for
mounting burner.
Step d.
Thread (1) 5/16-18 x 3/4 lg. cap screw,
approximately three (3) full turns, into
tapping located at 12:00 o’clock on burner
swing door.
Step e.
Insert oil burner into the opening of
burner swing door. Align and engage keyhole
slot in burner flange over head of protruding
cap screw installed in previous Step. Rotate
burner to the right to lock flange behind head
of cap screw.
Step f.
Align holes and install two (2) remaining
cap screws. Level burner and fully tighten all
three (3) screws.
Step g.
Plug burner power cord into Burner
Receptacle.
Step h.
Check oil nozzle in burner for size, angle
and spray type; inspect electrode settings and
head/air plate setting. Refer to Tables 9A, 9B
and Section X.
• Models EMP140E, EMP182E and
EMP224E - To install flueway baffle in
2
nd
pass flueway on left side of boiler,
hold baffle with word "Left" readable
at the top. Slide baffle in flueway until
position tab touches fins on right side
of 2
nd
pass flueway. To install flueway
baffle in 2
nd
pass flueway on right side
of boiler, hold baffle with word "Right"
readable at the top. Slide baffle in flueway
until position tab touches fins on left side
of 2
nd
pass flueway.
NOTE:
2
nd
and 3
rd
pass flueway baffle are not
interchangeable.
4.
Close the burner swing door
and securely
seal the door to the boiler front section by
reinstalling the hardware and securing the
door using procedure previously outlined in
Paragraph D of this section.
NOTICE:
When securing burner swing door
make sure door is drawn-in equally on both sides.
5.
Install oil burner .
(See Figure 8)
Step a.
Open burner carton and remove
contents.
Step b.
Place oil burner gasket on burner and
align holes.
Figure 8: Beckett Oil Burner Installation
2
Packaged Boiler Assembly - Trim
(continued)
CAUTION
Do not install burner without gasket.
!
