Problems
Causes
Countermeasures
Individual
turn signal
light does not
illuminate
Burnt out bulb
Check and renew
Corroded or loose bulb contacts
Inspect,clean,and renew
Poor ground connection or damage
wiring
Inspect,clean,and tighten connections or
renew wiring
Turn signal
pilot light is
inoperative
Faulty bulb
Check and renew
Defective flasher unit
Check and renew
Faulty wiring or connections
Inspect,clean,and tighten connections or
renew wiring
Stop lights
does not
illuminate
Inoperative stop light switch
Check and renew
See “Individual lights do not
illuminate”
See “Individual lights do not illuminate
Inoperative
work light
Work light switch is not turned on
Ensure work light illuminates
See “Individual lights do not
illuminate
See “Individual lights do not illuminate
Problems
Causes
Countermeasures
2. INSTRUMENTATION
10-16
Inoperative or
erratic meters
Loose or broken wiring
Inspect Circuit, tighten connections or renew
wiring
Defective meters
Inspect and renew
Defective sensors
Check and renew
Defective Voltage regulator
Check and renew voltage regulator (Alternator)
Monitor light
does not
illuminate
Loose or broken wiring
Inspect circuit,tighten connections or renew
wiring
Faulty main switch
Check and renew
Burnt out bulb
Check and renew
Burnt out fuse
Check and renew
Defective switch
Check and renew
Loose or broken wiring
Check and renew
PTO does not
operate
Burnt out fuse
Inspect and renew.Check circuit
Loose or broken wires or
connections
Inspect circuit,tighten connections,or renew
wiring
Defective PTO switch
Check and renew
Defective PTO solenoid
Check and renew
Summary of Contents for T233 HST
