TVT Digital Smart Management Terminal, User Manual

Page: 18 / 137

Basic Operation Guide SMT User Manual
10
2 Basic Operation Guide
2.1 Startup &Shutdown
Please make sure all the connections are done properly before you power on the unit. Proper
startup and shutdown are crucial to extending the life of your device.
2.1.1 Startup
①
Connect the output display device to the VGA/HDMI interface of the SMT.
②
Connect with the mouse and power. The device will boot and the power LED would turn
blue.
③
After you read the privacy statement, a WIZARD window will pop up (you should select
the display language the first time you use the SMT). Refer to 3.1 Startup Wizardfor details.
2.1.2 Shutdown
You can power off the device by using remote controller or mouse.
By remote controller:
①
Press the Power button. This will take you to a shutdown window. The unit will power off
after a while by clicking the ―OK‖ button.
②
Disconnect the power.
By mouse:
①
Click Start

Shutdown to pop up the Shutdown window. Select ―Shutdown‖ in the
window. The unit will power off after a while by clicking the ―OK‖ button.
②
Disconnect the power.
2.2 Remote Controller
①
It uses two AAA size batteries.
②
Open the battery cover of the remote controller.
③
Place batteries. Please take care the polarity (+ and -).
④
Replace the battery cover.
Key points to check in case the remote doesn’t work.
1. Check batteries polarity.
2. Check the remaining charge in the batteries.
3. Check IR controller sensor for any masking.
If it still doesn’t work, please change a new remote controller to try, or contact your dealers.
You can just turn the IR sensor of the remote controller towards the IR receiver of the SMT to
control it when you are controlling multiple devices by remote controller.
There are two kinds of remote controller. The interface of remote controller is shown as below.