Turf Tick Products Turf Tick, Original Instructions Manual

Page: 16 / 54

15
7.1.3. Speed main conveyor belts
The speed of the main conveyor belts is dependent to the driving speed. When the tractor is
driving with a higher speed in the same gear, the speed of the main conveyor belt is
simultaneously speeding up. It is important to drive in the right gear (chapter settings and
adjustments).
The fine-tuning of the speed from the main conveyor belts is possible by turning a hydraulic
valve (turning button 7).
7.1.4. Speed cutting knife
By turning the hydraulic valve (nr. 8). The maximum speed of the knife engine is adjusted, so
the speed of the cutting knife. This means that if the speed of the p.t.o.-shaft is increasing due
to speeding up the engine, the cutting knife speed is limited till the maximum adjusted speed.
When the number of revolutions of the p.t.o.-shaft is increasing even more the speed of the
cutting knife still remains limited at the maximum adjusted speed. Though the speed of the
main conveyor belt is increasing at a higher number of revolutions of the p.t.o.-shaft.
Turning of the hydraulic valve:
- First loosen the lock washer a little bit. This is the lower one of the two rings on the
valve. Before doing this loosen the hexagon socket head cap screws in the lock
washer.
- Turn the hydraulic valve with the upper ring in the desired position.
- Tighten the lock washer and hexagon socket head cap screws.
7.1.5. Cross conveyor
The speed of the cross conveyor can be adjusted by turning the hydraulic valve (nr. 9). The
cross conveyor is speeding up when the main conveyor belt is speeding up (higher number of
revolutions) the p.t.o.-shaft).
Turning of the hydraulic valve:
- First loosen the lock washer a little bit. This is the lower one of the two rings on the
valve. Before doing this loosen the hexagon socket head cap screws in the lock
washer.
- Turn the hydraulic valve with the upper ring in the desired position.
- Tighten the lock washer and hexagon socket head cap screws.
7.1.6.
Rotary brush
The rotary brush has a transport setting and a working setting. With button (nr. 15) the rotary
brush can be set from the transport setting to the working setting and the other way around.
The rotary brush starts turning when the hydraulic circuit is switched on (switch 2).