Turf Tick Products Turf Tick, Original Instructions Manual

Page: 33 / 54

32
If the fingers are stabbing too deep in-between the conveyor belts, the sod will only be folded
and no beginning of the roll is made.
If the fingers are stabbing not deep enough in-between the conveyor belt, the sod will not be
folded, only lifted up a little bit, so there is not made a beginning of a roll. In case of very
loose sods, it could be necessary that 1 of the 2 springs (parts book 101-50-30) is removed.
The right adjustment of the starting part is important and can be varied dependent on the type
en thickness of the sod.
II rolling board part
Schematically drawing rolling board part.
4 Choice of whole spring connection for height beginning rolling
board.
5 Choice of whole spring connection for height beginning rolling
board.
6 Adjustment height rolling board by choosing slot and hole.
7 Adjustment stop rubber height rolling board.
After making a beginning by folding the beginning of the sod, the rolling board is rolling a
part of the sod to a roll. Important for the adjustment of the rolling board is that the beginning
of the roll is passed through correctly from the starting part and that the changeover from the
rolling board to the rolling wheels is correct.
The most important adjustments from the rolling board are adjustment 6 and 7. With this you
can adjust the distance between the rolling board and the conveyor belt. Important is that the