3 TRANSPORT
The CENTERLINER spreader can be transported in the
tractor’s 3 point lift.
• Apply all such lighting and warning signals as are
mandatory by law.
• For transport on public roads care should be taken that
the front axle pressure is sufficient (fit front weights, if
necessary) and that the maximum rear axle pressure is
not exceeded.
The tractor is easier to control when the CENTERLINER
spreader’s hopper is empty. It is therefore recommended to
fill the hopper after arrival on the plot to be worked. This also
eliminates the kind of fertilizer compression that may occur
during transport.
It is possible to couple a trailed carriage to the CENTER-
LINER spreader’s chassis (fig. 6). In case of such an
attachment, the (total) weights allowed by law as a maximum
and further regulations should be taken into account.
Always take ample turns with the trailer to avoid that the
frame of the fertilizer spreader is damaged by the shaft.
Make sure never to couple a trailed carriage to the rear of
the CENTERLINER spreader when working with the
CENTERMATIC weighing element! Horizontal load on
the weighing element may cause a permanent inaccuracy.
43
6
!
