TRUST 750 LCD POWERC@M ZOOM
26
Problem
Cause
Possible solution
The batteries are
empty.
Replace the batteries (see
chapter 4).
The camera does
not react,
although the
batteries are full.
The camera must be
reset.
Disconnect the USB cable
and remove the batteries from
the camera. Reinsert the
batteries after approximately
10 minutes.
NiCd batteries are
used.
Use Alkaline or rechargeable
NiMH batteries (minimum
1800 mA).
The camera has not
been used for more
than 1 minute.
Turn the camera on again.
The camera
suddenly turns
itself off.
The power in the
batteries is low.
Replace the batteries.
The camera
cannot be turned
on or turns off
immediately.
The batteries are
empty.
Replace the batteries.
The camera was
moved when taking a
picture.
Try to hold the camera still or
use the stand.
The distance to the
object is too small.
Increase the distance to the
object to be photographed.
There is insufficient
light.
Improve the lighting.
The recordings
are not clear
(hazy).
The macro switch is
set to the wrong
setting.
Set the macro switch to the
correct setting.
The automatic
exposure is still turned
on.
Turn the automatic exposure
off.
The memory is full.
Transfer photographs to your
computer and delete the
memory. You can take many
more photographs using a
SD/MMC card. Ask your
dealer.
No photograph is
taken when the
exposure button
is pressed.
The camera is still
busy saving the
previous photograph.
Wait until the photograph has
been saved in the memory.
There is no
connection with
the computer.
The camera has been
connected incorrectly.
Reconnect the cables.
The camera does
not give an image
in the application
(webcam).
Another application is
open and is using the
camera image.
Close the other application
first before starting the
program.
A live recording
gives a displaced
image and the
wrong colours.
An old version of
DirectX is installed.
Install DirectX 8.1b from the
CD-ROM supplied with the
camera or download the latest
version from
www.microsoft.com/directx
