![background image](http://html1.mh-extra.com/html/troy-bilt/rzt-mustang-zt50/rzt-mustang-zt50_operators-manual_1173027026.webp)
Lubricate all lubrication points.
5.
NOTE:
Use a pressure washer or garden hose is not
recommended to clean your tractor. They may cause
damage to electrical components, spindles, pulleys,
bearings or the engine. The use of water will result in
shortened life and reduce serviceability.
Removing The Tractor From Storage
Check the engine oil.
1.
Fully charge the battery and inflate the tires to the
2.
recommended pressure.
If drained before storing, fill the fuel tank with clean, fresh
3.
gasoline.
Add clean, fresh fuel.
4.
Start the engine and allow to idle for a few minutes to ensure
5.
engine is operating properly.
Drive the tractor without a load to make certain all the tractor
6.
systems are functioning properly.
Adjustments
Adjusting the Seat
To adjust the position of the seat, pull up and hold the seat
adjustment lever. Slide the seat forward or rearward to the
desired position; then release the adjustment lever. Make sure
seat is locked into position before operating the tractor. See Fig.
6-4.
Adjusting RH & LH Drive Control Levers
The RH and LH drive control levers can be adjusted up or down
and fore-and-aft for the comfort of the operator. The drive
control levers can be placed in either of two height positions,
and/or can be moved forward or rearward within the range of
the slot in each control lever mounting bracket.
To adjust the drive control lever height, proceed as follows:
Remove the flange lock nut, flat washer, and hex screw securing
1.
the lever to the pivot bracket.
While supporting the control lever to keep it from falling,
2.
remove the hex insert flange lock nut and shoulder screw
from the bottom of the control lever and pivot bracket.
Refer to Fig. 6-5.
Reposition the control lever to align with the other set of holes in
3.
the pivot bracket and insert the shoulder screw removed
earlier. Fasten with the hex insert flange lock nut and
tighten until snug.
Insert the hex screw with washer through the control lever slot
4.
and the pivot bracket. Thread the flange lock nut onto the
screw, but do not tighten now.
If you are going to adjust the control levers forward or rearward,
5.
proceed to the next step. If not, fully tighten the flange lock
nut.
To adjust the drive control levers forward or rearward, proceed as
follows:
If not already loose, loosen the flange lock nut and rotate
1.
the control lever either forward or rearward to the desired
position. See Fig. 6-5.
NOTE:
If the control lever is too tight to move, slightly
loosen the hex insert flange lock nut and shoulder screw at
the bottom of the control lever.
Tighten the flange lock nut to fix the control lever in the adjusted
2.
position
Repeat the above procedure to adjust the other control lever into
3.
the same position. Adjust so that both levers are even with
each other when in the neutral position.
Figure 6-4
Control Lever
Pivot Bracket
Flange
Lock Nut
Height
Adjustment
Holes
Shoulder
Screw
Flat Washer
Hex
Screw
Figure 6-5
26
s
ectiOn
6— M
aintenance
& a
djustMents