Printer Control Codes
PcOS Series 90PLUS
Programmer's Guide
Station Control
Page 66
Rev Q
11/07/05
All feature control commands are extensions of the [ESC][EM] sequence. They are defined as follows.
Function
Validation clamp delay
ASCII
[ESC] [EM] C <n>
Hexadecimal
1BH 19H 43H <n>
Decimal
<27> <25> <67> <n>
IPCL
&%ZC <m
1
> <m
2
>
EPOS
[ESC] f
Description
The [ESC] [EM] C <n> command sets slip clamp delay. Slip clamp delay is the
time between when the slip is sensed and the form is clamped. (Only the smallest
4 bits are used.) The default is configurable.
Where <n>:
0
0 ms
1
50 ms
2
150 ms, and so on until
15
750 ms
Note
The command must be issued before the station select command. The validation
clamp delay is active for front and top validation form insertion. Once issued, the
value will be used until the printer is power cycled or the command is reissued.
Function
Set slip validation time out
ASCII
[ESC] [EM] S <n>
Hexadecimal
1BH 19H 53H <n>
Decimal
<27> <25> <83> <n>
IPCL
&%ZS <m
1
> <m
2
>
EPOS
[ESC] f
Description
The [ESC] [EM] S <n> command sets the time out after a front validation
command is issued and the printer returns to receipt mode.
Where <n> is the delay in one minute increments, the minimum time out is 1
minute, and the maximum is 15 minutes. If <n> = 0, the delay is set to no time
out (waits forever). The default is configurable.
Function
Set validation time out
ASCII
[ESC] [EM] V <n>
Hexadecimal
1BH 19H 56H<n>
Decimal
<27> <25> <86> <n>
IPCL
&%ZV <m
1
> <m
2
>
EPOS
[ESC] f
Description
The [ESC] [EM] V <n> command sets the time out after a top validation
command with autosense is issued and the printer returns to receipt mode.
Where <n> is the delay in one minute increments, the minimum time out is 1
minute, and the maximum is 15 minutes. If <n> = 0, the delay is set to no time
out (waits forever). The default is configurable.
Summary of Contents for Ithaca 90PLUS Series
Page 2: ...Page ii Rev Q 11 07 05...
Page 12: ......
