TransAct Ithaca 90PLUS Series, Programmer'S Manual

Page: 131 / 172

Programmer's Guide PcOS Series 90PLUS Product Self Tests
11/07/05 Rev Q Page 119
Recommendation
Cash drawer
time
The amount of time the cash drawer is energized is
adjustable from 25 to 250 milliseconds. This value will be
dependent on the cash drawer being used; however, 150
milliseconds work with most drawers.
25 to 250 milliseconds (50 milliseconds resolution) 150 ms
M50
compatibility
The Series 50 Printer uses several commands that are not
supported by the Series 90PLUS Printer. These commands
(in some cases) have different functions in the Series
90PLUS Printer. If the Series 50 compatibility commands
are activated, the overlapping Series 90PLUS commands
will be deactivated.
Off •
On
Reverse cash
The designation of the cash drawers can be reversed.
drawers
Normal
•
Reversed
Print zone There are two print zone settings.
Normal 2.8 inches •
Narrow 2.4 inches
Reset inhibit
The reset commands can be prevented from being acted
on. If reset inhibit is set to “on,” the command will have no
effect. (This does not effect the parallel port INIT signal).
Off •
On
Print
suppress and
pass-through
There is a print suppress feature that can be off, on, or
pass-through. How this feature is setup will determine the
operation of the print suppress command. If the print
suppress command is set to off, the command will be
ignored. If the command is on, print suppress will be active.
If pass is selected, the command and data pass-through will
be active.
Off
•
Suppress
Pass-through
Graphic-save
Lock Off •
On
Print illegal
Commands
No •
Yes
Vertical Control
Line spacing The line spacing can be defaulted to 6 or 8 lines per inch
(lpi).
6 lpi
8 lpi •