TransAct Ithaca 90PLUS Series, Programmer'S Manual

Page: 21 / 172

Programmer's Guide PcOS Series 90PLUS General Specifications
11/07/05 Rev Q Page 9
Roll footage 240 feet (7315.2 cm) typical
Paper low indicator striping starts at approximately 8 - 10 feet (243.8 - 300.5 cm) from end of roll
Receipt paper out Paper exhaust is sensed, and printing is prevented at end of roll.
3.4.3 Receipt/Journal Paper
Paper feed method friction feed
Paper feed pitch default,
1/8
inch; can be set in units of
1/216
inch by software command
Paper width 2.5, 3.0, or 3.25 inches (63.5, 76.2, or 82.6 mm)
Roll diameter 3.5 inches (88.9 mm)
Paper thickness at 25
°
C
Two-ply 0.006 - 0.007 inch (0.15 - 0.18 mm)
Three-ply 0.009 - 0.0105 inch (0.23 - 0.27 mm)
Roll paper core inside diameter, 7/16 inch
Typical roll footage
Two-ply 110 feet (3352.8 cm)
Three-ply 70 feet (2133.6 cm)
Paper low indicator striping starts at approximately 8 - 10 feet (243.8 - 300.5 cm) from end of roll
Receipt paper low The paper level is sensed by software with an adjustable end of roll monitor that
prevents printing.
3.4.4 Inserted Slips and Forms
Paper width 2.50 - 9.0 inches (63.5 - 228.6 mm)
Length 3.375 - 11.0 inches (85.7 - 279.4 mm)
Paper thickness a. one sheet: 0.0035 - 0.016 inches (0.089 - 0.41 mm) at 25
°
C
b. combination of copy paper and carbon copy paper:
4 sheets maximum (one original and three copies)
c. maximum form thickness: 0.016 inches (0.41 mm) at 25
°
C